Monsters University Game in a BluRay Case

Make a Monsters U game inside a BluRay Case

I bought the pre-sale of Monsters University on BluRay, and made some cute Monsters U Countdown blocks to go with it. I’ll be mailed the movie when it comes out… which leaves me with a BluRay case that has no movie in it. (PS – I also made Monsters U Juice Box Printables and a Mike Wazowski t-shirt if you’re into Monsters U crafts)

Monsters U Movie presale copy

I thought I’d turn the movie case into a little portable game in a BluRay Case. This is super simple to do, I’ve got all the printables ready to go… here is what you need.

Print the new BluRay Game Cover on standard paper
Print the BluRay Game Pieces on cardstock
Sharp scissors with a pointy end (or scissors and a craft or hobby knife)
Double-sided tape
Paper fastener (aka a Brad)

After you print out the Monsters University Game pieces, cut them out.

Open up the BluRay case and pull out the old cover, slip the new BlurRay Game Cover into place.

Monsters U Game made from BluRay Case

Leave the case open so that you can see the inside. You’ll want to use sharp scissors or a craft knife to cut away the raised lip on the left side. It is about 3/4″ down from the top. Just trim it down as close to the base as possible. Now you can slip the game board in on the left side.

On the right side, use the point of your scissors or the sharp point of a craft knife to carefully make a circle in the very center of the circle that holds the BluRay movie. You’ll want your hole to be about 1/4″ in diameter. Carefully cut away any plastic that gets pulled up when you make the hole. Be careful not to damage the cover or plastic on the other side.

Cut a hole in the center of the large numbered circle so that it slips over the raised center, and use double sided tape to stick it in place where the DVD would go. Use the tip of your scissors or the brad itself to make a hole in the center of the spinning arrow. Insert the brad into the arrow, an then into the hole you made in the raised center circle. Fasten the brad on the back LOOSELY. You want to make sure it still spins easily.

Fold your game pieces, and use a small piece of double sided tape to stick the bottom flaps together.

You’re ready to play your game in a BluRay Case!

Monsters U Game inside a BluRay Case

Subscribe to our mailing list!

Comments

  1. Such a cute idea for the DVD case when you pre-order!

Speak Your Mind

*